Table of Contents
Advertisement
6. Counting Pieces
To implement piece-counting, the specified samples are loaded on the balance, and their average unit
weight (hereinafter, simply the "unit weight") is entered and saved. The procedure for saving unit
weights is called sampling.
The counting procedure consists of loading articles that have already been sampled on to the balance.
The number of pieces is then calculated by dividing the total weight of the loaded articles by the unit
weight saved in memory. Piece counting cannot be implemented unless sampling has already taken
place.
Sampling
Counting Pieces
Weight
10g
Number of samples
10 pieces
Total weight
_ 500 g
Sample unit weight
1 g
=Sample
unit weight
= 500 pcs.
= Measured
number of
samples
JKIf samples to be counted deviate widely in weight, or a higher measure of accuracy is desired, it is
recommended that users use the "Raising the Counting Accuracy" method. This procedure results
in greater precision by increasing the number of samples used in the sampling operation.
6.1 Sampling
1
Activating the counting mode
Pcs
Press the | Function | key to display
[Pcs].
2
Resetting the indication to zero
Pcs
a
Place the tare and press the
I Zero/Tare~| key.
The tare is subtracted and the balance
now indicates zero.
3
Starting the sampling
Press the | Set | key.
The display flashes a number, such as
[o n
I £?]. This means that ten
samples are to be loaded.
The sampling number that was used in
the previous sampling will be displayed
here.
17
Advertisement
Table of Contents
