Mitsubishi Electric PUHY-200YMF-B Service Handbook page 60

2) Method of retrieval/confirmation
• Retrieval/confirmation of group registration information on indoor unit ............... 2
The address of the indoor unit being registered on the remote controller is displayed.
[Operation procedure]
1 With the remote controller under stopping or at the display of "HO", continuously press the
+ B) at the same time for 2 seconds to change to the registration mode.
2 In order to confirm the indoor unit address already registered, press
of plural sets is registered, the addresses will be displayed in order at each pressing of
3 After completing the registration, continuously press the
seconds to change to the original ordinary mode (with the remote controller under stopping).
CENTRALLY CONTROLLED
CHECK
˚C
STAND BY INDOOR UNIT
DEFROST ADDRESS NO.
TEMP.
NETWORK
REMOTE CONTROLLER
PAR-F25MA
1 Press the switch for confirmation (E)
• Retrieval/confirmation of registration information ................................................ 3
The registered information on a certain unit (indoor unit, outdoor unit, remote controller or the like) is displayed.
[Operation procedure]
1 With the remote controller under stopping or at the display of "HO", continuously press the
+ B) at the same time for 2 seconds to change to the registration mode.
2 Operate
3 Assign the unit address of which registration information is desired to confirm with the
(H). Then press the
Each pressing of switch (E) changes the display of registered content. (See figure below.)
4 After completing the retrieval/confirmation, continuously press the
for 2 seconds to change to the original ordinary mode (with the remote controller under stopping).
ON/OFF –
1Hr.
ON OFF ˚C
CLOCK
FILTER
CHECK MODE
ERROR CODE
TEST RUN
NOT AVAILABLE
OA UNIT ADDRESS NO.
CLOCK ON OFF
FILTER
CHECK
TIMER SET
TEST RUN
switch (G) for the interlocked setting mode. (See figure below.)
switch (E) to display it on the remote controller. (See figure below.)
switch (E). (See figure below.) When the group
switch (A + B) at the same time for 2
+
FILTER
• Registered
Indicates the type of unit
1
(Indoor unit in this case)
1
• No registration.
Note: Only one address will be displayed
+
FILTER
–58–
+
FILTER
switch (E).
˚C
INDOOR UNIT ERROR CODE
ADDRESS NO OA UNIT ADDRESS NO
˚C
INDOOR UNIT ERROR CODE
ADDRESS NO OA UNIT ADDRESS NO
when the registration is one even the
switch is how often pressed
+
FILTER
(TIMER SET) switch
switch (A + B) at the same time
switch (A
switch (A