Hitachi BD-S5500 Operating Instructions Manual page 12

Lights or blinks when the door is locked.
HIGH TEMP Lights or blinks when the inside of the drum is hot.
DRY FILTER Blinks when the dry filter is clogged or after every 20 times the <<WASH DRY>> and <<DRY>> are
operated.
LINT FILTER Blinks when the lint filter is not attached properly or clogged, or after every 30 times the <<WASH>>
and <<WASH DRY>> are operated.
OVERLOADED Blinks when the laundry load is too large to dry.
Setting the
DOOR LOCK
(P. 35)
Set the machine to finish
Prevent children
operation 3 to 12 hours
from opening
later in 1-hour increments.
the door.
The
indicator and
[DOOR LOCK]
appear when
this is set.
Turn the backlight auto-off function on or off.
Adjust the spin speed during the dry cycle of
<<WASH DRY>> operations.
Adjust the spin startup conditions.
Set or release the [DOOR LOCK].
Caution indicators (P. 33, 34, 76 to 79)
The selectable programs light in turn with each press of
the <<WASH>>, <<WASH DRY>>, or <<DRY>> button.
The selectable programs differ for each of the <<WASH>>,
<<WASH DRY>>, and <<DRY>> operations.
Turn the power on or off.
If you turn the power on and do not start operation within 10
minutes, the power will turn off automatically.
The power turns off automatically after operation is finished.
(Auto Power Off)
Start or pause an operation.
If you press the <PAUSE> button during drying, you cannot
open the door until the inside of the drum has cooled.
Make sure that the door is closed before pressing the button.
Failure to do so may result in malfunction of the machine.
Using the DELAY
START function
(P. 62, 63)
Delay timing cannot be set
for some programs.
The [BLANKET], [DELICATE]
and [TUB CLEAN] programs,
and all <<DRY>> operations
cannot be delayed.
(P. 70,
P. 71)
(P. 35)
Select a program (P. 36 to 59)
Power buttons (P. 83)
START/PAUSE button (P. 33, 34)
Using the AUTO SELF CLEAN function
(P. 4, 75)
Wash away dirt adhered to the invisible parts
of the machine, such as the outer side of the
drum, automatically.
After washing laundry, you can start drying
operation to dry the drum.
This function is disabled at the factory.
This function cannot be used in the [BLANKET],
[DELICATE] and [TUB CLEAN] programs, and all
<<DRY>> operations.
Change the dehumidification mode (Air/
Water Cooling).
Turn the residual water discharge function
during the <AUTO SELF CLEAN> operation
on or off.
(P. 74)
(P. 74)
11