Table of Contents
Advertisement
5.3 Error Message List
Message
There is a time period when more than 16
cameras are recording. It is recommended
that you limit the recording set to 16 or
fewer cameras. If you continue recording
in this state, the cameras may not be able
to record properly.
Import/Export
Message
An error occurred during importing. (**)
•
** =
•
File Type
•
File Size
•
Memory Shortage
•
Open
The number of registered cameras
reached the maximum of ** cameras, so
importing was canceled.
•
** =
The number of registered cameras (1
or 64)
Other Errors
Message
Software Startup failed. Restart this
software. If situation does not improve
after restarting the software, restart your
PC.
Program Error occurred during program
execution. If the same error message
appears after trying again, restart your
PC.
The number of registered cameras
exceeds the maximum registration
number 64. Please delete ** or more
cameras and try again.
Cannot find '**'. Make sure the path or
Internet address is correct.
Specify a local drive. Although mapping
this folder to a network drive allows you to
specify this folder, the program may not
perform normally due to your network
environment, and therefore, specifying a
network drive is not recommended.
182
Operating Instructions
Cause and Remedy
•
There are too many cameras recording at once.
→
Please review the manual recording settings or the timer
recording settings to decrease to 16 or fewer cameras.
Cause and Remedy
•
This software cannot import from the file at
[Settings]-[Import].
→
The file is corrupted.
•
If the maximum number of registered cameras is exceeded
during import.
→
Delete unnecessary cameras.
Cause and Remedy
•
This software fails to start the ncrcore4.exe file.
→
Restart your PC.
•
This software fails to start the ncr4.exe file.
→
Restart your PC.
•
Follow the instruction message.
→
Delete ** or more cameras and try again.
•
The file may have been manually deleted.
→
Install this software again.
•
A network drive or folders on the network were selected as
the save destination folder.
→
Specify a local drive.
Advertisement
Table of Contents
