Table of Contents
Advertisement
Message
Enter an English one-byte character in
User Name.
Enter an English one-byte character in
Password.
Camera Name should be 250 characters
or less.
Comment should be 128 characters or
less.
Camera Name: *****
Delete the specified camera.
Port is already set on the camera settings.
Cannot input port number over again in the
Camera Address. Check the port number
and try again.
Connection to the camera cannot be
confirmed. The IP address, port number,
proxy settings may be incorrect. Do you
save them?
Connection to the camera cannot be
confirmed. The IP address, port number,
or proxy settings may be incorrect. Check
your settings and try again.
The camera authentication is not
available. Enter the correct user name and
password, and try again.
Some settings are unavailable because
the functions of the selected camera have
not been confirmed. Execute Check the
Camera Function.
Because the camera address is an IPv6
address, a proxy server cannot be used.
To use a proxy server, set the camera's
address to an IPv4 address or a URL that
has been registered to an IPv4 domain
name service.
Image Settings
If using the MPEG-4 (H.264) format, the
event recording (Motion Detection, Alarm
Detection, etc.) are not available.
Cause and Remedy
•
When the authentication user name consists of inadmissible
characters.
→
Enter an English one-byte character in User Name.
•
When the authentication password consists of inadmissible
characters.
→
Enter an English one-byte character in Password.
•
The Camera Name was more than 250 characters.
→
Enter a camera name in 250 characters or less.
•
The Comment was more than 128 characters.
→
Enter a comment in 128 characters or less.
→
Delete the specified camera.
•
When 2 ports are set up.
→
The same port number cannot be used for the camera
settings and the camera address. Check the port
number and try again.
•
The camera cannot be accessed.
→
Select [Yes] to perform settings, select [No] to confirm
settings.
→
Please check the authentication method on the camera.
You can only use this program with Basic authentication.
•
The camera cannot be accessed.
→
Confirm the IP address, port number, and proxy settings
and try again.
→
Please check the authentication method on the camera.
You can only use this program with Basic authentication.
•
This software do not pass the camera authentication.
→
Confirm the user name and password and try again.
→
Execute [Check the Camera Function].
→
To use a proxy server, set the camera's address to an IPv4
address or a URL that has been registered to an IPv4
domain name service.
→
Event recording settings (Motion Detection, Alarm
Detection, etc.) cannot be set.
5.3 Error Message List
Operating Instructions
177
Advertisement
Table of Contents
