Toshiba GR200 Series Instruction Manual page 674

Operate logic for SBO/DIR modes
4.4.3
After the completion of the operation of the select logic, the operate logic enters to clear all
interval OTs.
Wait for a command
Select logic
Command Reset from the
remote-end
Figure 4.4-9 Outline of operate command for resetting intervals OT1 to OT4
Input signal required mapping
(i)
Figure 4.4-10 shows the operate logic when an "Operation command (Reset)" signal enters the
OPTIM function. The input-point "OPTR_CONTROL_REQ" is used for the reception of the
"Operation command (Reset)" signal, which is the same point of the select logic.
Input
Command "Operating reset"
529001 700C016D08 OPTR01_CONTROL_REQ
"Automatic sequence control function (AQEQ)§"
in progress
From the operation on the front panel
Reset All
Figure 4.4-10 Operate logic for resetting intervals OT1 to OT4
Output signal required to map
(ii)
The operate logic issues a "OPRT_RST_CMD" signal to clear all intervals OT1 to OT4. The
signal "OTS_RST_CMD" can be transferred to the remote-end, when mapping the signal is
carried out in the IEC61850 communication. (See section 4.4.4)
Wait for a next command
Operate command from the remote-end
Signal reception in
IEC61850
Operate command from the local-end
Selecting "Reset All"
Cancel logic
Cancel command
Cancel logic
OPTIM function (Function ID: 529001)
Operate command
Operate condition‡
ASEQ_MULTI_SEL
- 653 -
Operation
Operate logic
decision
Failed
Operation
Operate logic
decision
Failed
Selection logic in OPTR
OPTR01_RST_CMD
529001 310C011EA1
&
≥
6F2S1915 (0.46)
Success
Resetting OTs
Do nothing
Success
Resetting OTs
Do nothing
Output
Reset all OTs
GRZ200 (Soft 031 & 032)