8.3. Load the board data and change the conveyor width
Load the board data for calibration and change the conveyor width as same as the line alignment jig to
be used.
Tips
As to YSP10, it is necessary to load the board data before changing the conveyor width.
Select the board data "CALIB_B0301_PRINTER".
See the YSP10 User's manual for details.
[Board data select] screen
Press the [Unit] button.
Press the [Unit] button on the left part of the application screen.
Select the [Conveyor] tab.
Select the [Conveyor] tab on the upper part of the [Unit] screen.
SI1906002E-001=YSP10 installation and adjustment procedures
33/120
For Service Engineers
Service Information
[Setup] screen