Bring In The Machine To The Installation Site - Yamaha YSP10 Service Information

3. Bring in the machine to the installation site

This section describes procedures from bringing in the machine to the installation site up to installing it
provisionally.
Bring in the machine to the installation site.
Make sure that the machine and all necessary items are prepared and bring them to near the installation
location.
Remove plastic wrapping from the machine.
Note
To ensure operator safety, DO NOT use a cutting knife to remove plastic wrapping. Use scissors
instead.
Install the machine provisionally.
When the machine is brought in close to the installation location, place the machine on the floor
provisionally on the levelling bolts. Take care not to stamp on the tracing tapes or erase location
markings set by the customer. When the provisional installation is complete, check with the customer if
the machine location is appropriate.
Note
Place the machine near its previous (or next) machine considering the line alignment procedure.
Note
Communicate sufficiently to the customer so that they understand sufficient space is required
around the machine. The machine could be much bulkier than the customer would expect from the
line layout drawing, which could hinder setup work or workers passing by.
If possible insert a pair of sliding paper under four leveling bolts
respectively. See "9.3 Adjust the machine horizontal level and
conveyor height.", Step 3 for information.
SI1906002E-001=YSP10 installation and adjustment procedures
13/120
For Service Engineers
Service Information
Place the machine near
its installation location
provisionally.