Toshiba e-STUDIO2010AC Imaging Manual page 66

2.Copier-specific Adjustments
increase or decrease the sharpness intensity by "25". If the sharpness intensity of the center value
is changed, each step of the indicator will be changed accordingly. (For instance, if the center
value is increased by "25" (sharper), the value of each step of the indicator will also be increased
by "25" (sharper).)
• However, the range of adjustment values that is valid for sharpness level change is from -100 to
+100 of the total of the setting value of the [05] code and that of the indicator. For instance, if the
setting value of the [05] code is "103" ("-25" from the default value), the limit of the steps in the soft
side of the indicator is "-3". If the step is set at "-4", the image quality will not be changed.
Soft
Default:
Setting value "103":
After increasing the sharpness intensity, copy and check the copy image quality.
If further image quality adjustments are still necessary, perform the next procedure.
(6) Select [05 ADJUSTMENT MODE] and change the values of the codes [7840], [7841] and [7842] to
adjust the reproduction level of the Text/Photo, User Custom and Red Seal Color original modes.
The larger the value is, the clearer the reproduction of thin text will become.
Original mode [05] Code
Text/Photo 05-7840
User Custom 05-7841
Red Seal Color 05-7842
• Adjustment for the User Custom setting is enabled in the Text/Photo mode base only.
• Set the value in increments of 1, while checking the copy image until the optimum value is
obtained.
Set the value to "5" and check the copy image quality. If further image quality adjustment is
necessary, set the value to "6". If further adjustment is necessary, increase the value step by step.
• If a value becomes too much larger, a photo area may become coarse.
• If "4" to "1" is set for the setting value, the text may become blurred.
• For the User Custom mode, refer to "2.19 To Program Frequently Used Copy Settings (To use
Custom Mode)".
• The setting content of the value "5" is the same as that for the default value "0".
© 2018 TOSHIBA TEC CORPORATION All rights reserved
-4 -3 -2 -1 0
| | | | |
-100 -75 -50 -25 0
-100 -100 -75 -50 -25
Since "-25" is assigned to the center, the image quality
remains the same even if the indicator is changed from "-3" to
"-4".
Recommended value
Set a value larger than 5.
2-12
+1 +2 +3 +4
Sharp
| | | |
+25 +50 +75 +100
0 +25 +50 +75
Acceptable value range
0 to 9
e-STUDIO2010AC/2510AC/2515AC/3015AC/3515AC/4515AC/5015AC
Assigned
adjustment value
of sharpness
Default
0