Siemens SINAMICS S120 Commissioning Manual page 217

Module
Motor Module
Cable for connection to direct measurement systems: Order number 6FXx002-2CB54-xxxx
1)
Commissioning information
The index [0..n] used in the following identifies either the motor data set or the encoder data
set.
SMC10/SMC20
You can use the STARTER screen (\signals and monitoring \ motor temperature) to
parameterize the motor temperature evaluation via SUB-D socket X520.
SMC30 (from Order No. 6SL3055-0AA00-5CA2)
In addition to temperature evaluation via terminal X531 (temperature channel 1), this module
also has temperature evaluation at SUB-D socket X520 (temperature channel 2).
At the default setting (p0600 = 1 "Temperature via encoder 1" and p0601 = 2 "KTY") the
temperature is evaluated via the first temperature channel. The temperature sensor is
connected to terminal X531 on the SMC30. The temperature is shown via r0035.
The parameterization of the motor temperature evaluation via the sub D socket X520 must
be performed in the expert list as follows:
● p0600[0..n]: Selection of the encoder (1, 2 or 3) to which the SMC30, that is used for the
● p0601[0..n] = 10 (evaluation via several temperature channels), n = motor data set.
● p4601[0..n]: Select the temperature sensor type for temperature channel 2 (depends on
The temperature is displayed in parameter r4620[1] (temperature channel 2). For multiple
temperature channels (use of temperature channels 1 and 2 on SMC30), parameter r0035
shows the maximum temperature.
Commissioning Manual
Commissioning Manual, (IH1), 01/2013, 6SL3097-4AF00-0BP3
Interface Pin
Booksize 1
X21/X22 (terminal) 2
The following 4
applies to chassis: 3
X41 (terminal)
temperature evaluation, is assigned (n = motor data set).
encoder data set n, not motor data set).
Note
With several encoders, the index [n] of the relevant encoder / encoder data set, via which
the temperature evaluation is performed, must be used.
2.16 Temperature sensors for SINAMICS components
Signal name Technical specifications
Temperature sensor
+Temp
KTY84–1C130 / PTC
- Temp
Bimetallic switch with NC contact:
+Temp
Alarm and timer (only for
- Temp
temperature evaluation via MM)
PT100 temperature sensor
Commissioning
215