Siemens SINUMERIK 840DE sl Commissioning Manual page 571

Display fit-dependent corrections in the operating area "Parameters" → "Work offsets" window:
MD52211 $MCS_FUNCTION_MASK_DISP_ZOA
Bit 22
Details of disk size
MD52842 $MCS_GRIND_DIAMETER_LENGTH
MD52843 $MCS_GRIND_WIDTH_LENGTH
Form-truing (CYCLE495)
SD55880 $SCS_GRIND_CONT_RELEASE_ANGLE
SD55881 $SCS_GRIND_CONT_RELEASE_DIST
SD55884 $SCS_GRIND_CONT_BLANK_OFFSET
SINUMERIK Operate (IM9)
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
Display fit-dependent corrections ($P_GFRAME)
= 1 Length 1 is disk diameter
= 2 Length 2 is disk diameter
= 1 Length 1 is disk width
= 2 Length 2 is disk width
This setting data is used to specify the angle of retraction from the contour during form-truing.
This setting data is used to specify the distance retracted in both axes during form-truing.
This setting data is used to specify the distance to the grinding wheel as of which the switch‐
over is made from G0 to G1 during form-truing.
Technologies and cycles
21.6 Grinding
Function screen Display overview of
work offsets
Number of the tool length for the disk
diameter
Number of the tool length for the disk
width
Angle of retraction
Retraction distance
Blank allowance
557