Suzuki SY413 Service Manual page 1836

1. Gear shift control housing
2. Control lever guide plate
3. Gear shift control lever
4. Bolt
5. Control lever boot
1. Shift control lever
2. Control housing
3. Shim
4. Control lever seat
5. Lock washer
6. Housing nut
REMOVAL
1. Extension rod
On Lift
2. Housing nut
1) Disconnect gear shift control shaft from gear shift control lever
3. Control lever guide
plate
by removing control shaft bolt and nut.
4. Guide plate bolt
5. Gear shift control 2) Remove 4 guide plate bolts and loosen extension rod nut at
shaft
transmission end and then move extension rod aside.
6. Exhaust No.1 pipe
7. Gear shift control
lever
8. Control shaft bolt &
nut
In Cabin
1) Remove shift control lever cover by removing 4 screws.
2) Remove 4 control lever housing nuts and then push shift control
lever boot(s) into floor hole to take out shift control lever assem-
bly from under the floor.
On Bench
1) Holding control lever knob with soft jawed vise, loosen its screw
and remove control lever.
2) Remove 2 housing nuts, and then disassemble control lever.
INSTALLATION
1) Assemble control lever by reversing removal procedure, re-
placing parts with new ones as required. Select shim for adjust-
ing vertical play of control lever, if necessary.
Apply grease to turning or sliding portions.
NOTE:
Check control lever for smooth movement after assembly.
Control lever vertical play
Available shim size (thickness)
MANUAL TRANSMISSION (G13 AND G16 ENGINE MODELS) 7A-11
0 – 0.2 mm
(0 – 0.007 in)
0.8, 1.0, 1.2 and 1.4 mm
(0.03, 0.04, 0.05 and 0.06 in)