Suzuki SY413 Service Manual page 2025

7B-86 AUTOMATIC TRANSMISSION (3 A/T)
1. Countershaft spacer
1. Output shaft bearing
2. Bearing puller
3. Soft jawed vise
1. Seal ring
2. Output shaft
3. Bearing
4. Bearing puller
1. Bearing (inside)
1. Bearing (cover side) 2. Output shaft
2) Install snap ring.
3) Install countershaft spacer to case.
4) Install another countershaft bearing (ball bearing) to case.
Use special tools (Bearing installer attachment and installer
handle).
5) Install bearing backing plate and snap ring.
Output Shaft Bearings
Removal
1) Remove cover side bearing.
Hold output shaft with soft jawed vise and remove bearing by
using bearing puller.
2) Install inside bearing.
Hold bearing by using bearing puller and drive out shaft with
press.
CAUTION:
Never hit shaft end where seal ring is installed so as
not to distort ring slit.
Installation
1) Install inside bearing.
Use special tool with press.
Special Tool
(A): 09913-85210
2) Install cover side bearing.
Hold shaft at parking lock gear and press-fit bearing by using
special tool with press.
Special Tool
(B): 09944-66020