Suzuki SY413 Service Manual page 1464

1B-30 AIR CONDITIONING (OPTIONAL)
4) Remove lead wire clamp.
5) Remove felt ring and shims from shaft.
6) Using special tool (C), remove circlip.
Special Tool
(C): 09900-06107
7) Remove magnet clutch lead wire clamp screw, and disconnect
magnet clutch read wire.
8) Remove magnet clutch with puller.
NOTE:
Be careful not to damage pulley when tapping magnet
clutch.
9) Remove magnet clutch coil.
1. Puller
2. Compressor
Installation
1) Install magnet clutch coil.
Protrusion on under side of coil ring must match hole in com-
pressor assembly to prevent movement and correctly locate
lead wire.
2) Using special tool (C), install snap ring as shown.
Special Tool
1. Snap ring
(C): 09900-06107
2. Clutch coil
3. Compressor
3) Clamp covering portion of read wire.
assembly
4) Install magnet clutch.
À
Set magnet clutch squarely over clutch installation boss.
Á
Place special tool (D) onto clutch bearing.
Ensure that edge rests only on inner race of bearing.
Â
Install snap ring.
Special Tool
(D): 09991-06010
CAUTION:
Be careful not to scratch bearing seal.