4.5.12
Platen sensor (S6) / Carriage home position sensor (S7)
(1)
Take off the upper rear cover.
P. 4-4 "4.1.7 Upper rear cover"
(2)
Disconnect 1 connector. Release the latches
and take off the platen sensor.
(3)
Remove the seal on the carriage home
position sensor.
(4)
Disconnect 1 connector. Release the latches
and take off the carriage home position
sensor.
4.5.13
SLG board (SLG)
(1)
Take off the lens cover.
P. 4-26 "4.5.2 Lens cover"
(2)
Disconnect 7 connectors, remove 4 screws
and take off the SLG board.
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
DISASSEMBLY AND REPLACEMENT
Platen sensor
SLG board
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
4 - 44
Seal
Carriage home
position sensor
Fig. 4-128
Fig. 4-129