Honda 2010 Ridgeline Owner's Manual page 79

10/01/26 18:35:38 31SZA620_078
Vehicle Stability Assist
(VSA) System Indicator
This indicator normally comes on for
a few seconds when you turn the
ignition switch to the ON (II)
position.
If it comes on and stays on at any
other time, or if it does not come on
when you turn the ignition switch to
the ON (II) position, there is a
problem with the VSA or Hill Start
Assist systems. Take your vehicle to
a dealer to have it checked. Without
VSA, your vehicle still has normal
driving ability, but will not have VSA
traction and stability enhancement.
See page 431 for more information
on the VSA system.
On vehicles with navigation system
You will also see a ''CHECK VSA
SYSTEM'' message on the multi-
information display (see page
95 ).
VSA Activation Indicator
This indicator normally comes on for
a few seconds when you turn the
ignition switch to the ON (II)
position. For more information, see
page .
431
This indicator has three functions:
1. It comes on as a reminder that you
have turned off the vehicle
stability assist (VSA) system.
2. It flashes when VSA is active (see
page 431 ).
3. It comes on along with the VSA
system indicator if there is a
problem with the VSA or Hill Start
Assist systems.
On vehicles with navigation system
You will also see a ''CHECK VSA
SYSTEM'' message on the multi-
information display (see page
Instrument Panel Indicators
Turn Signal and
Hazard Warning
Indicators
The left or right turn signal indicator
blinks when you signal a lane change
or turn. If an indicator does not blink
or blinks rapidly, it usually means
one of the turn signal bulbs is
burned out (see page
the bulb as soon as possible, since
other drivers cannot see that you are
signaling.
When you press the hazard warning
button, both turn signal indicators
and all turn signals on the outside of
the vehicle flash.
95 ).
484 ). Replace
73