Advertisement
ENGINE STARTING AND STOPPING PROCEDURES
Starting
When the engine
is
cold (ie. left stopped for more
than 5 minutes) or when fuel is added t o the engine:
1
)
First place the machine on the ground.
2)
Give a gentle push
on
the primer pump repeatedly
(7
-
10 times) until fuel comes into the primer
pump.
3)
Close
the choke lever.
4) Push the stop switch t o "START"
position (or
opposite of "STOP" position).
5) For RBC230 / RBC261 / RBC311
Squeeze the throttle lever fully. Then release the'
throttle lever while depressing the throttle lock
button. The throttle lever will now be locked in the
"start-up" position.
For RBC260 and RBC310
Press the "LOCK-OFF" switch before squeezing
the throttle lever. Then squeeze the throttle lever
fully. Release the throttle lever while depressing the
throttle lock button. The throttle lever will now be
locked in the "start-up" position.
I
( 1 )
Primer pump
( 2 )
C h o k e lever
R B C 2 3 0
/
R B C 2 6 1 i R B C 3 1 1
I
R B C 2 6 0
/
R B C 3 1 0
( 1
I
S t o p s w i t c h
I
R B C 2 3 0
/
R B C 2 6 1 / R B C 3 1 1
I
R B C 2 6 0 / R B C 3 1 0
1
( 1
)
T h r o t t l e lever
( 2 ) T h r o t t l e l o c k b u t t o n
(3)
LOCK-OFF s w i t c h
6) Hold the holder case firmly by
your left hand and
give several strong pulls t o the starter by your right
hand.
7) After the engine is started, open the choke lever
fully, checking the engine running condition.
G i v e several s t r o n g pulls t o t h e starter.
* Immediately after the engine is stopped:
Only perform the Nos. 1, 4 and 6 described above.
8
Advertisement
