Advertisement
HOW TO OPERATE
The nylon cord will feed out automatically to a pre-determined length when you decrease and increase the engine
speed of your string trimmer. You do not need t o tap the nylon cutting head to let the nylon cord feed out.
If the nylon cord does not feed out automatically, decrease the engine speed fully and then increase it fully.
The nylon cord will feed out automatically. If the nylon cord still does not feed out sufficiently, perform the
same procedures repeatedly until the nylon cord feeds out to the proper length. If the nylon cord is too short
to feed out automatically by performing the above procedures, stop the engine and pull out the nylon cord by
hand or using pliers more than 40 m m (1-9116"). Then perform the above procedures again.
Increase speed
Increase speed
Decrease speed
Lowest speed
Full speed
Lowest speed
Full speed
CAUTION:
NEVER OPERATE THE ENGINE AT HIGH RPM WITHOUT LOAD. With throttle fully opened and no load, the engine
rpm will be very high which can have an adverse effect on the life of the engine.
10
Advertisement
