Advertisement
ASS E M B LY IN STR U CTI
0
N S
1. Assembly of engine and pipe case
For RBC230 I RBC261
I
RBC311
Remove the protector at the end of the pipe case.
Insert the pipe case into the holder case being sure
t o match the splines of the inner shaft t o those
inside the holder case.
Match the hole in the pipe case t o the hole in the
holder case and fasten the pipe case t o the engine
with damper bolt, wave washer and washer.
(Tightening torque: 70
~
100 kg.cm;
5
~
7
ft.lbs)
CAUTION :
Securely tighten the damper bolt, which is one of
the important parts mating the engine and machine
body.
For RBC260 and RBC310
Install the pipe case (the end
with
circular metal
housing) over the clutch assembly and fix with four
socket head bolts and fix tightly with hex wrench.
2.
Mounting of handle
For RBC230 I RBC261
I
RBC311
As shown at right, tighten the loop handle with
three socket head bolts.
Mount the handle so that the throttle wire guide
will he oriented t o the right, as viewed from the
engine side.
The standard position of the handle is 200 t o 2 5 0
mm
(7-718"
~
9-718") from the hanger. Position
the handle according t o a worker's stature and
working conditions.
171
a 0
1 4 1
151
161
11
1
Holder case
121
Hole
131
Pipe case
(41
Washer
151
Wave washer
161
Damper bolt
171
Hole
I l l
Pipe case
121
Hex wrench
131
Socket head bolt
5
Advertisement
