Table of Contents
Advertisement
1. Switch trigger
ASSEMBLY
1
1. Wrench
2. Shaft lock
1
2
3
1. Saw blade
2. Hex bolt
3. Outer flange
4. Inner flange
OPERATION
10
Switch action
001396
1
CAUTION:
•
Before plugging in the tool, always check to see that the
switch trigger actuates properly and returns to the "OFF"
position when released.
To start the tool, simply pull the switch trigger. Release the
switch trigger to stop.
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Removing or installing saw blade
001417
CAUTION:
•
Be sure the blade is installed with teeth pointing up at
the front of the tool.
•
Use only the Makita wrench to install or remove the
2
blade.
To remove the blade, press the shaft lock so that the blade
cannot revolve and use the wrench to loosen the hex bolt
counterclockwise. Then remove the hex bolt, outer flange
and blade.
To install the blade, follow the removal procedure in reverse.
001434
BE SURE TO TIGHTEN THE HEX BOLT CLOCKWISE
SECURELY.
When changing blade, make sure to also clean upper and
lower blade guards of accumulated sawdust. Such efforts do
not, however, replace the need to check lower guard opera-
4
tion before each use.
CAUTION:
•
Be sure to move the tool forward in a straight line gently.
Forcing or twisting the tool will result in overheating the
motor and dangerous kickback, possibly causing severe
injury.
Advertisement
Table of Contents
