Advertisement
2.
Installing the blades
Provide a flat wood block approx.
150 mm (5-29/32") long and 100 mm
(3-1 5/16") wide. Place the blade and
s e t
plate on the wood block so that the
blade locating lug of the set plate rests
in the groove of the blade. Adjust the
set
plate so that both ends of the blade
do not protrude from the ends of the
s e t
plate. Place the two magnetic holders
on the set plate and push them until the
claw contacts the blade. (Note: Use the
correct claw for jointer.)
Lock the drum in the position whereby
the blade installation bolts face upward.
Place the set plate and blade on the
drum so that the heads of the depth
adjusting screws in the drum f i t into the
square holes in the set plate. Remove
the magnetic holders while holding the
set
plate with your hand.
Place the drum plate on the set plate.
Install the blade installation bolts and
semi-tighen them.
16
Advertisement
