Advertisement
2. Installing the blades
Provide a flat wood block approx.
300 mm (1 1-13/16") long and
100
mm
(3-15/16") wide. Place the blade and
set
plate on the wood block so that the
blade locating lug of the set plate rests
in the groove of the blade. Adjust the
s e t
plate so that both ends of the blade
protrude approx. 1 mm (3/64") beyond
the end of the
set
plate. Place the two
magnetic holders on the
set
plate and
push them until the claw contacts the
blade (Note: Use the correct claw for
auto-planer.
Grip the magnetic holders and slip the
heel of the
set
plate into the groove in
the drum. Install the blade installation
bolts.
After tightening all the blade installa-
tion bolts lightly and evenly from the
center to the outside, tighten them com-
pletely following
the
same sequence.
Remove the magnetic holders from the
set
plate.
I
Magnetic holder
Set plate
(3/64")
Blade
~
Blade installation bolt
Magnetic holder
-Socket
wrench
Magnetic holders
13
Advertisement
