Maintenance - Makita AN923 Instruction Manual

CAUTION:
• Always lock the trigger, disconnect the hose and
remove the nails from the magazine before clean-
ing a jam.
When the nailer becomes jammed, do as follows:
Insert a small rod or the like into the ejection port and tap
it with a hammer to retract the driver.
Use pliers to bend the jammed nail so that the nail head
comes out of the slot in the driver guide. Then remove
the jammed nail.
Nails
Handle nail coils and their box carefully. If the nail coils
have been handled roughly, they may be out of shape or
their connector breaks, causing poor nail feed.
Avoid storing nails in a very humid or hot place or place
exposed to direct sunlight.

MAINTENANCE

CAUTION:
• Always disconnect the air hose from the tool before
attempting to perform inspection or maintenance.
004309
1. Pliers
2. Slot
1
2
004310
004311
Maintenance of nailer
Always check the tool for its overall condition and loose
screws before operation. Tighten as required.
With tool disconnected, make daily inspection to assure
free movement of the contact element and trigger. Do not
use tool if the contact element or trigger sticks or binds.
Make sure that the trigger is locked when the change
lever is set to the
When the tool is not to be used for an extended period of
time, lubricate the tool using pneumatic tool oil and store
the tool in a safe place. Avoid exposure to direct sunlight
and/or humid or hot environment.
7
007015
007016
position.
007017
1. Trigger lock
2. Change lever
1
2
007018