Advertisement
To tighten the lock nut, hold the spindle with
the wrench so that it cannot revolve, then
use the lock nut wrench and securely tighten
clockwise.
Lock
nut
w e n c
I f
\ - wrench
CAUTION:
Use only the Makita wrench and lock nut wrench provided to install or remove the wheel.
Failure to do so may result in overtightening or insufficient tightening of the lock nut. This
could cause an injury.
To remove the wheel, follow the installation procedure in reverse.
Switch
action
To start the tool, move the slide switch
forward, and the slide switch will lock in the
"ON" position.
T o
stop lightly depress the
rear of the slide switch, and it will return t o
the "OFF" position.
Slide switch
I
0
I
CAUTION:
Before plugging in the tool, always check to see that the switch actuates properly and
Be sure to clean the tool often to prevent dust/dirt/abrasive material build-up from inter-
returns to the "OFF" position when depressed.
fering with the smooth operation of the swtich.
6
Advertisement
