How To Use - Makita HP1030 Instruction Manual

19.
20.
21.
replaced by an authorized service center unless otherwise indicated elsewhere in this
instruction manual. Have defective switches replaced by authorized service center.
Don't use tool if switch does not
turn it on and off.
When drilling into walls, floors or whatever "live" electrical wires may be encoun-
tered. DO NOT TOUCH THE CHUCK OR ANY FRONT METAL PARTS OF THE
DRILL. Hold
the
Drill only by the plastic handle or the side grip t o prevent electric
shock if you drill into a ''live'' wire.
GUARD AGAINST ELECTRIC SHOCK.
Prevent body contact with grounded surfaces. For example; pipes, radiators, ranges,
refrigerator enclosures.
REPLACEMENT PARTS. When servicing, use only identical replacement parts.
SAVE THESE INSTRUCTIONS.
VOLTAGE WARNING: Before connecting the t o o l t o a power source (receptacle, outlet, etc.) be sure
the voltage supplied
is
the same as that specified o n the nameplate of the tool.
A
power source with
voltage greater than that specified for the t o o l can result in SERIOUS INJURY t o the user
-
as well as
damage t o t h e tool.
If
in doubt,
DO
NOT PLUG I N THE TOOL.
Using a power source with voltage
l e u than the nameplate rating is harmful t o the motor.
How to use
0
Drill Chuck
When installing a drill bit with the chuck
key, notice that there are three holes
in the chuck where the bit should be
tightened, not just one. Tighten evenly
at all
three holes in order.
(as you
moved
mount a tire.)
0
For Drilling Only (Rotation Alone)
For drilling in steel or wood, twist the
indicator on top of the tool so that the
drilling indication
(-\-)
in on the
side with the small diamond convex.
This provides drilling by itself. Use a con-
ventional bit for drilling metal or wood.
Fig.
1
I
I
I
Diamond convex
I
Fig.
2
3