Advertisement
IMPORTANT SAFETY INSTRUCTIONS
FOR CHARGER &
BATTERY CARTRIDGE
1.
SAVE THESE INSTRUCTIONS
-
This manual
contains important safety and operating instructions for battery charger.
2. Before using battery charger, read all instructions and cautionary markings
on
(1
1
battery charger,
(21
battery, and
(3)
product using battery.
3.
CAUTION
-
To
reduce risk of injury, charge only MAKITA Battery Cartridge
7000, 7001, 7002, 7033, 7100, 7120,
9000, 9001, 9002, 9033, 9100,
9101,9102,9120,9122,9133,1200,1201,1202,1210,1211,1222,1233,
1422,1433,1822,1833,9101A.
9102A. 1201A or 1202A. Other types of
batteries may burst causing personal injury and damage.
4. Do not expose charger t o rain or snow.
5.
Use of an attachment not recommended or sold by the battery charger
manufacturer may result in a risk of fire, electric shock, or injury t o persons.
6. To
reduce risk of damage t o electric plug and cord, pull by plug rather than
cord when disconnecting charger.
7. Make sure cord is located
so
that it will n o t be stepped on, tripped over, or
otherwise subjected t o damage or stress.
8.
A n extension cord should n o t be used unless absolutely necessary. Use of
improper extension cord could result in a risk of fire and electric shock. If
extension cord m u s t be used, make sure:
a. That pins o n plug of extension cord are the same number, size, and shape
b. That extension cord is properly wired and in good electrical condition; and
c. That wire size is at least as large as the one specified in the table below.
TABLE 1
RECOMMENDED MINIMUM AWG SIZE
FOR
EXTENSION CORDS
FOR
BATTERY CHARGERS
I
Length of Cord (Feet)
I
2 5
I
50
I
100
I
1 5 0
I
as those of plug on charger;
I
AWG S i z e o f Cord
1
18
I
18
I
18
I
16
I
9.
Do n o t operate charger w i t h damaged cord or plug
-
replace t h e m im-
mediately.
I O . Do
not operate charger if
it
has received a sharp blow, been dropped, or other-
wise damaged in any way; take
it
t o a qualified serviceman.
11. Do not disassemble charger or battery cartridge; take it t o a qualified
serviceman when service or repair is required. Incorrect reassembly may
result in a risk of electric shock or fire.
12. To
reduce risk of electric shock, unplug charger from outlet before attempt-
ing any maintenance or cleaning. Turning off controls will not reduce this risk.
6
Advertisement
