Advertisement
3. Holders and holder assembly
(optional accessories)
The holders and the holder assembly
can be installed on either side as a con-
venient means of supporting workpieces
horizontally. Install them as shown in the
figures below. Then tighten the screws
firmly to secure the holders and the
holder assembly.
When cutting long workpieces, use the
holder-rod assembly (optional accesso-
ry). It consists of two holder assemblies
and two rods 12.
Hoider Holder assembly
Holder assembly
I
CAUTION:
Always support long workpieces level with the top surface of the turn base for accurate
cuts and to prevent dangerous loss of control of the tool.
OPERATION
Switch action
CAUTION:
Before inserting the battery cartridge into the tool, always check to see that the switch
*When not using the tool, remove the lock-off button and store it in a secure place. This
trigger actuates properly and returns to the "OFF" position when released.
prevents unauthorized operation.
17
Advertisement
