Casio DT-X100 Series User Manual page 42

1 USB Client Port
2 USB Host Port
3 Power Switch
4 Selector Switch
5 LAN Connection
Status LED
6 LAN
Communication
Status LED
7 LAN Port
8 AC Adaptor Jack
9 Terminal Detect
Switch
10 Power Contacts
11 Communication
Terminal
12 Power LED
13 Mount Hooks
E-40
This port is used to transmit data and files (download, upload) by
connecting the Ethernet Cradle to a PC using a USB cable
(DT-380USB-A). The dedicated driver must be installed in the
PC before connecting the Ethernet Cradle to the PC.
This port is used to connect a corresponding USB peripheral
device.
Turns the power on and off.
This switch is used to switch between a USB connection and a
LAN connection.
This LED shows the status of the LAN connection.
Off: LAN cable not connected correctly.
Lit green: LAN cable connected correctly.
This LED shows the LAN operation status.
Off: No communication.
Blinking green: Communication in progress.
This port is used for connecting the cradle to a PC or hub via a
LAN cable so that data and files can be transmitted (uploaded or
downloaded).
The special driver software must be installed in the DT-X100.
Connect the AC adaptor here.
This switch detects when the DT-X100 is seated correctly on the
Ethernet Cradle.
Power is supplied to the DT-X100 via these contacts.
Used for communications.
This LED indicates the power status and the mounting status of
the DT-X100.
Off: DT-X100 is not installed. Or, the AC adaptor is not
connected.
Green: Power on, DT-X100 mounted correctly.
Use these hooks to lock the DT-X100 into the cradle.