Installing/Removing Driver Bit/Drill Bit - Makita 6311D Instruction Manual

installing or removing driver bit or drill b i t
CAUTION:
Always be sure
that the
tool
is
switched
off
and
the
battery cartridge
is
removed before
instaliing or removing the bit.
Hold the ring and turn the sleeve counter-
clockwise to open the chuck jaws. Place
the bit in the chuck as far as it
will go.
Hold the ring firmly and turn the sleeve
clockwise t o tighten the chuck.
To remove the bit, hold the ring and turn
the sleeve counterclockwise.
Switch action
Tool speed is increased by increasing pres-
sure on the trigger. To start the tool, simply
pull the trigger. Release the trigger to stop.
I
Sleeve
CAUTION :
Before inserting the battery cartridge into the tool, always check t o see that the switch
trigger actuates properly and returns t o the
"OFF"
position when released.
Reversing switch action
This tool has a reversing switch to change
the direction of rotation. Slide the revers-
ing switch to the left for clockwise rota-
tion or t o the right for counterclockwise.
CAUTION:
0
Always check the direction of rotation before operation.
.Move the reversing switch only after the tool comes t o a complete stop. Changing the
direction of rotation before the tool stops may damage the tool.
7