Configuration Mode - Honda iST Owner's Manual

Configuration Mode

Enter Configuration Mode
1
• Turn System Power Off
• All engines must be turned off
2
• Move control station handles to
Full Throttle position
• Turn System Power On
3
• Only turn on the ignition switch
of one engine to on position
4
• Press & release WARM (on 8-button
keypads, SLOW on 2-button
keypads) button three times
• All LEDs begin flashing
• This is the Configuration Mode Main Menu
5
• Make desired changes following the menu &
selection instructions to the right
• After configuration
6
changes are made, turn
the ignition switch OFF and
then ON again to restart
the control system.
OFF
1
Cycle through menu options
ON
Press and release the SYNC (on 8-button keypads, SEL
on 2-button keypads) button to cycle through menus.
Menu options will be shown by the number of times the
SYNC (on 8-button keypads, SEL on 2-button keypads)
LED flashes. Refer to the chart on page 14 to see
which LED combination indicates which menu.
OFF
ON
2
Select desired menu
Press and release the SLOW (on 8-button keypads,
WARM on 2-button keypads) button to enter into
the selected menu.
The menu selection will remain flashing on the SYNC
LED (on 8-button keypads, SEL LED on 2-button
keypads), followed by the current configuration
setting, indicated by the SLOW LED (on 8-button
keypads, WARM on 2-button keypads).
OFF
OFF
ON
ON
PRESS TO CYCLE
Allows you to set speed increments, define the startup mode, and reset to
factory settings.
Choose Menu & Select
NEUTRAL NEUTRAL
WARM
SLOW
PRESS TO SELECT
multi-engine keypad
Choose Option & Select
1
Cycle through available settings
for selected menu
Press and release the SYNC button (on 8-button
keypads, SEL on 2-button keypads) to cycle through
menus.
SLOW LED (on 8-button keypads, WARM on 2-button
keypads) will flash the appropriate number of times to
indicate the new selection for that menu item. Refer to
the chart on page 14 for the list of menu settings.
Store the desired setting for the
2
selected menu item
Press and release the SLOW button (on 8-button
keypads, WARM on 2-button keypads) to store the
selected setting.
The system will automatically return to the main
configuration menu with all the LEDs flashing.
After configuration changes are made, turn the
3
ignition switch off and then on again to restart the
control system.
NEUTRAL
SLOW
PRESS TO CYCLE
single engine keypad
13
WARM
PRESS TO SELECT