Trim Control - Honda iST Owner's Manual

Trim Control

1
Control All Engines
Simultaneously
NOTE:
System must be on for trim on
control handle to work.
Control Handles may be in any position to operate trim
control.
Toggle up to trim outboard in an upward position.
Toggle down to trim outboard in a downward position.
Used for single engine boats
This allows the boat operator to control the trim/tilt of the engine drive unit from the control
handle or keypad.
To control all engines trim simultaneously, press and
release trim toggle switch located on the port control
handle.
Used for multi engine boats
2
Control Port & Starboard
Separately
Individual trim for three or four engines is done on an
auxiliary panel.
With each press and release of the trim buttons, the
engine drive units will respond incrementally. For large
movements of the engine drive unit, buttons will need
to be pressed and held until desired position is reached.
To control port and starboard trim/tilt separately, press
and release port or starboard trim button located on the
center of the keypad.
9