Operation - Makita TD090D Instruction Manual

For European and North & South American
countries, Australia and New Zealand
Use only these type of bit. Follow the
A=12mm
procedure (1).
B=9mm
(Note) Bit-piece is not necessary.
006348
For other countries
To install these types of bits, follow
A=17mm
the procedure (1).
B=14mm
(Note) Makita bits are these types.
To install these types of bits, follow
A=12mm
the procedure (2).
B=9mm
(Note) Bit-piece is necessary for
installing the bit.
006349
1. To install the bit, pull the sleeve in the direction of
the arrow and insert the bit into the sleeve as far as
it will go. Then release the sleeve to secure the bit.
1
2
008815
2. To install the bit, pull the sleeve in the direction of
the arrow and insert the bit-piece and bit into the
sleeve as far as it will go. The bit-piece should be
inserted into the sleeve with its pointed end facing
in. Then release the sleeve to secure the bit.
2 3
1
008816
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out firmly.
NOTE:
If the bit is not inserted deep enough into the
•
sleeve, the sleeve will not return to its original
position and the bit will not be secured. In this
1. Bit
2. Sleeve
1. Bit
2. Bit-piece
3. Sleeve
7
case, try re-inserting the bit according to the
instructions above.

OPERATION

008819
The proper fastening torque may differ depending upon
the kind or size of the screw/bolt, the material of the
workpiece to be fastened, etc. The relation between
fastening torque and fastening time is shown in the
figures.
Standard bolt
N.m
(kgf.cm)
80
(816)
60
(612)
M10
40
(408)
20
M8
(204)
0
1.0 2.0 3.0
Fastening time
008823
High tensile bolt
N.m
(kgf.cm)
80
(816)
60
(612)
M8
40
(408)
20
(204)
0
1.0 2.0 3.0
Fastening time
008825
M12
M12
M10
M8
(S)
M10
M10
M8
(S)