Problems With Windows Server 2003 - NEC Express5800 120Li User Manual

Hide thumbs Also See for Express5800 120Li:
Table of Contents

Advertisement

User Guide
- Make sure to lock the hard disk with the lever on its handle. The hard disk is not
connected to the internal connector when it is not completely installed.
Fail to access the (internal or external) SCSI devices:
■ Is the SCSI device applicable to the server?
- Operation of any SCSI device that is not authorized by the manufacturer is not
guaranteed.
■ Are SCSI devices properly configured?
- When the server has external SCSI devices connected, devices settings, includ-
ing SCSI ID and terminator, are required. Refer to the manual that comes with
the SCSI device for details.
■ Are the SCSI controllers (including optional controllers) properly configured?
- Use the BIOS SETUP utility for proper configuration of SCSI devices con-
nected to the SCSI connector on the motherboard. When the server has an
optional SCSI controller installed and SCSI devices connected to it, use the
BIOS Setup utility that comes with the optional SCSI controller for proper con-
figuration. See the manual that comes with the optional SCSI controller for
details.

Problems with Windows Server 2003

Windows Product Activation
This copy of Windows must be activated with Microsoft before you can continue. You
cannot log on until you activate Windows. To shut down the computer click Cancel.
In Windows Server 2003, the above message will be displayed if you use the operating
system without executing the license authentication. Select "Yes", and execute the
procedure for license authentication.
Cannot install the operating system correctly.
■ Did you check the notes on installing the operating system?
During installation, the following warning is registered in the System Log of the Event
Viewer:
Error detected on the device \Device\CdRom0 during the paging operation.
- There is no problem on this issue.
Fail to start the OS:
■ Is a floppy disk in the floppy disk drive?
- Take out the floppy disk and restart the server.
■ Is the NEC ExpressBuilder CD-ROM in the DVD-ROM drive?
- Take out the NEC ExpressBuilder CD-ROM and restart the server.
197
www.nec-computers.com

Advertisement

Table of Contents
loading

Table of Contents