Table of Contents
Advertisement
User Guide
Installing with the OEM-FD for Mass Storage Device
This section explains how to setup with the OEM-FD. You usually do not have to do as
follows. If you want to install other boards by using a driver floppy disk, set the server
as follows. Detailed information is provided in the manual of the mass storage device.
Installation of mass storage device not supported by ExpressSetup
If you would like to install the OS when the system has new mass storage device not
supported by NEC ExpressBuilder, you have to setup as follows.
1. Read the manual supplied with the mass storage device before setting the
server.
2. If the mass storage device is disk array controller, configure the RAID system
before running the NEC ExpressBuilder.
3. Boot the system from NEC ExpressBuilder CD-ROM.
4.
5. Copy the driver for the mass storage device in the ExpressSetup.
6. Insert the FD attached the mass storage device into the FD drive.
7. Follow the on-screen instructions to continue the ExpressSetup.
(a) When the message "Do you want to use the parameters file..."
appears , select "Yes".
(b) When the dialog of Disk array configuration appears, check "Use
Existing Array"
(c) Check "Apply OEM-FD for Mass storage device"
260
www.nec-computers.com
Advertisement
Table of Contents
