Controls & Components - Grizzly G0490 Owner's Manual

Controls &
Components
To reduce your risk of
serious injury, read this
entire
using machine.
Refer to Figures 1–3 and the following descrip-
tions to become familiar with the basic controls of
this machine.
STOP
Button
Figure 1. STOP/START button locations.
START Button: Starts motor only if the STOP
button is in the out position.
STOP Button: Stops motor when pushed in and
disables the START button. Enable the START
button by twisting the STOP button clockwise until
it springs forward in the out position.
Table Movement: To move the infeed table,
loosen the table lock (see Figure 2), position
the table with the table adjustment lever in the
preset range, then tighten the table lock. The
outfeed table is preset with no range of movement
allowed, so if it gets accidentally unlocked it will
not move.
-4-
manual BEFORE
START
Button
Table
Locks
Outfeed Table
Adjustment Lever
Figure 2. Locations of table locks and levers.
Fence Movement: The fence has a lock that
keeps it in position (see Figure 3). To move the
fence, loosen the lock and slide the fence where
needed.
Plunger
Figure 3. Locations of fence controls.
Fence Tilting: The tilt lock (see Figure 3) secures
the fence at any position in the available range.
The plunger locks into an indexing ring to easily
set the fence tilt to 90° after moving it. Two posi-
tive stops enable the fence to be positioned at 45°
inward and 45° outward for common 45° bevel
cuts. Even when the fence is resting against the
fence stops, the tilt lock must be tightened before
cutting.
Model G0490/G0490X (Mfd. Since 8/12)
Infeed Table
Adjustment Lever
Tilt
Lock
Fence Lock