Grizzly G0490 Owner's Manual page 22

19. Visually check alignment of cutterhead and
motor pulleys, as illustrated in Figure 15.
Alignment
Figure 15. Pulleys aligned.
— If they are not aligned, loosen the four
mounting carriage bolts shown in Figure 16,
shift motor horizontally to align pulleys,
then retighten carriage bolts.
Mounting
Carriage
Bolts
Figure 16. Motor adjustment controls.
20. Use the two pre-installed cap screws and flat
washers to install fence carriage to rear of
jointer assembly, as shown in Figure 17.
-20-
Cutterhead
Pulley
Motor
Pulley
Fence Carriage
x 2
Figure 17. Fence carriage installed.
21. Wrap poly V-belt around cutterhead and
motor pulleys, as shown in Figure 18. Make
sure ribs of V-belt are seated in pulley
grooves.
Figure 18. Poly V-belt installed.
Model G0490/G0490X (Mfd. Since 8/12)