Linksys EtherFast PCM200 v2 User Manual page 19

6. NT will then display a window containing several setting types. Keep the
default settings unless you know that you need to change them.
After you have made the appropriate settings, click OK.
7. NT will probably ask you to supply your original Windows NT CD-ROM
or setup disks. Direct Windows NT to the proper location (e.g.,
D:\i386). Click Continue.
8. Click on the Protocols tab. Add any protocols you require by clicking the
Add button.
9. After your bindings, settings, and services are set, click the Close button.
10. Remove your Driver Disk and click Yes to restart your PC.
32
Linksys Instant EtherFast Series
®
N N o o t t e e : : If you install the
T T C C P P / / I I P P p p r r o o t t o o c c o o l l , refer to
your system administrator
or your Windows NT doc-
umentation when installa-
tion steps that aren't list-
ed in this User Guide
appear. Linksys does not
provide technical support
for the configuration or
troubleshooting of the
TCP/IP protocol.
EtherFast 10/100 CardBus PC Cards
®
11. Once your PC has rebooted, double-click the Network Neighborhood
icon on your desktop. Ensure that you have access to the network. If you
do, you card has been properly installed.
• If you had previously installed any NT service packs, you must go back
and re-install those service packs now.
If you need to install the TCP/IP protocol, refer to your system administra-
tor or your Windows NT documentation. Linksys does not provide techni-
cal support for the configuration or troubleshooting of the TCP/IP proto-
col
The Windows NT EtherFast Card Installation and Setup is complete.
33