Linksys EtherFast PCM200 v2 User Manual page 12

If Windows asks you to supply a file containing the letters "cb102.sys" or
"pc200" , type "a:\" in the box that pops up as shown below. Click OK.
During the installation, Windows may ask you for a computer and workgroup
name. If so, refer to instructions 9-11 on page 19. Otherwise, continue with
the installation.
Windows will finish copying all of the necessary files to your system. When
asked if you want to restart your computer, click No.
Once you are back at the Windows 95 desktop, click on the Start button.
Click on Settings, then Control Panel.
5. Double-click on the Network icon. The Network window will appear.
Click on the Configuration tab.
6. Make sure that the following network components are installed:
Client for Microsoft Networks
Linksys EtherFast 10/100 CardBus PC Card II
IPX/SPX-compatible Protocol
NetBEUI
TCP/IP
18
Linksys Instant EtherFast Series
®
EtherFast 10/100 CardBus PC Cards
®
There may be other components listed, this is fine. However, if any compo-
nents listed above are missing, you'll need to install them manually. Refer to
Manually Installing the Network Components section on page 46.
If you need to install the TCP/IP protocol, refer to your system administrator
or your Windows 95 documentation. Linksys does not provide technical sup-
port for the configuration or troubleshooting of the TCP/IP protocol.
7. In the Primary Network Logon box (see previous page), select Client for
Microsoft Networks.
8. To enable File and Printer Sharing, put a check mark next to both boxes in
the File and Print Sharing window. Click OK.
9. Click on the Identification tab. Type the name of your computer in the
Computer name box. Make up a name that is unique from all the other com-
puters' names on the network. (e.g., Dino, Alpha, etc.)
10. Type the name of your workgroup in the Workgroup box. The name you
type should be the same workgroup name in use by all of the other PCs on
the network. The Workgroup box may be case sensitive. Use the same case
that is in use on your other computers.
11. Enter a description of your computer in the Computer Description box.
This box is optional.
19