Windows 2000 Installation And Setup - Linksys EtherFast PCM200 v2 User Manual

Windows 2000 Installation and
Setup
Overview
After physically installing the EtherFast 10/100 CardBus PC Card in your
computer, follow these instructions to install the network driver.
N N o o t t e e : : Screen shots used in this Installation and Setup section are
from installation of the standard EtherFast 10/100 CardBus PC
Card (PCMPC200 v2). If you are installing the EtherFast 10/100
Integrated CardBus PC Card (PCM200 v2), the installation process
will be unchanged, however, the product name will be different.
1. Start your computer and boot up Windows 2000.
2. Windows will display the Found New Hardware Wizard box.
Click Next.
3. The Install Hardware Device Drivers dialog box will appear.
When Ethernet Controller is displayed, select "Search for a suitable driver for
your device (Recommended)". Click Next.
22
Linksys Instant EtherFast Series
®
EtherFast 10/100 CardBus PC Cards
®
4. The Locate Driver Files dialog box will appear.
Select the "Floppy disk drives" option, insert the Linksys EtherFast
10/100 CardBus PC Card Driver Disk into your floppy drive. Click Next.
5. The Driver File Search Results dialog box will appear. Click Next.
6. The Completing the Found New Hardware Wizard dialog box will appear.
The following adapter name will be shown:
Linksys EtherFast 10/100 CardBus PC Card II
Click Finish.
7. Remove any disks from your disk drives.
Installation is complete.
If you want to share files or printers,
refer to the Windows 2000 documentation
23