Cisco 2900 Series Installation Manual page 192

Replacing Power Supplies and Redundant Power Supplies
Table 5-2
Power Mode
2911 in POE
Boost
2921, 2951 in
POE Boost
Installing an RPS Adapter
To install an RPS adapter, perform the following steps:
Caution The RPS adapter must be in the router chassis before connecting to the RPS.
Step 1 Read the
perform any module replacement.
Step 2 Ensure AC or DC power is disconnected from the router power supply.
Step 3 If connected, place the RPS 2300 into standby mode. Consult the
Hardware Installation Guide
Step 4 If an RPS Adapter had never been installed, a blank panel is in its place. Remove the RPS Adapter blank
panel.
Insert the RPS adapter into the router
Step 5
Step 6 Connect the RPS 2300 cable into the RPS adapter connector.
Step 7 Connect the other end of the RPS 2300 cable to the RPS 2300.
Step 8 Power up the router.
Place the RPS into Active mode.
Step 9
Removing an RPS Adapter
To remove an RPS adapter, perform the following steps:
Read the
Step 1
replacement.
If connected, place the RPS 2300 into standby mode. Consult the
Step 2
Hardware Installation Guide
Power off and disconnect the AC or DC power from the router power supply.
Step 3
Remove the RPS cable from the RPS 2300.
Step 4
Remove the other end of the RPS 2300 cable from the RPS adapter.
Step 5
Remove the RPS adapter.
Step 6
Cisco 2900 Series and 3900 Series Hardware Installation Guide
5-42
RPS 2300 Backup Capabilities (continued)
Quantity 1
C3K-PWR-750WAC
0
0
"Safety Warnings" section on page 5-2
for operating the RPS 2300.
Safety Warnings section and disconnect the power supply before you perform any module
for operating the RPS 2300.
Chapter 5 Installing and Upgrading Internal Modules and FRUs
Quantity and Type of RPS 2300 FRU
Quantity 2 Quantity 1
C3K-PWR-750WAC C3K-PWR-1150WAC
1
1
section and disconnect the power supply before you
(Figure 5-29 or Figure 5-30) and tighten the screws.
Quantity 2
C3K-PWR-1150WAC
1
0
Cisco Redundant Power System 2300
Cisco Redundant Power System 2300
2
1