Auto-Configuration (For Single-Cabinet Systems Only) - Panasonic DBS 576 Technical Manual

Section 400: Programming

Auto-Configuration (for single-cabinet systems only)

Introduction
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B
576-20-400
This procedure will automatically configure a single-cabinet system for a selectable
set of pre-defined settings (see table, next page).
1. Set the CODE rotary switch to 1.
2. Set the RAM HOLD switch to OFF.
3. Hold in the MODE button on the CPC card,
and either press the RESET button or power-
on the system.
•
Wait for the MN LED to come on before
releasing the MODE button.
4. Move the RAM HOLD switch to ON.
5. At an installed extension display phone, press
ON/OFF. The phone should display:
Pattern #:0
Range : 1 - 6
6. Dial the desired System Configuration
Pattern No. 1-6 (see table, next page).
7. Press HOLD.
8. Press ON/OFF.
9. Wait for the initialize auto-configuration
process to complete.
Successful completion will be indicated by
the system returning to normal operating
mode (the main screen will appear on the
phone):
MSG
DBS 576 (USA) issued January 1999
Introduction to
00:07 Wed JAN 01
100 EXT100
PERSONAL DIAL
SYSTEM DIAL
EXTENSION
FUNCTION SYSTEM
FUNCTION EXT
CONF MENU PREV NEXT PROG
DBS 576
Programming
The CPC-96 Card
(front edge, facing out from cabinet)
CN3
(for PC Upgrade Kit)
RUN LED (MPU)
MJ LED
MN LED
RAM HOLD switch
RESET button
CODE rotary switch
MODE button
MOH plug-in
•
Page Intro-7
Introduction
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B