Dell S4810 Reference Manual page 1490

tacacs-server key
tacacs-server host
Specify a TACACS+ host.
S4810
Syntax
tacacs-server host {hostname | ipv4-address | ipv6-address}
[port number] [timeout seconds] [key key]
Parameters
hostname
ipv4-address |
ipv6-address
port number
timeout
seconds
key key
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.4.1.0
Version 8.3.7.0
Version 7.7.1.0
Version 7.6.1.0
1490
— configures a TACACS+ key for the TACACS server.
Enter the name of the TACACS+ server host.
Enter the IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X)
of the TACACS+ server host.
(OPTIONAL) Enter the keyword port then a number as the
port to be used by the TACACS+ server. The range is from
zero (0) to 65535. The default is 49.
(OPTIONAL) Enter the keyword timeout then the number of
seconds the switch waits for a reply from the TACACS+
server. The range is from 0 to 1000. The default is 10
seconds.
(OPTIONAL) Enter the keyword key then a string up to 42
characters long as the authentication key. This
authentication key must match the key specified in the
tacacs-server key for the TACACS+ daemon.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Added support for IPv6.
Introduced on the S4810.
Authentication key length increased to 42 characters.
Introduced on the S-Series.
Security