Qos-Policy-Input - Dell S4810 Reference Manual

qos-policy-input

Create a QoS input policy on the router.
S4810
Syntax
qos-policy-input qos-policy-name cpu-qos | layer2
To remove an existing input QoS policy from the router, use the no qos-policy-
input qos-policy-name cpu-qos | layer2 command.
Parameters
qos-policy-
name
cpu-qos
layer2
Defaults Layer 3
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Usage
Use this command to specify the name of the input QoS policy. Once input policy
Information
is specified, rate-police can be defined. This command enables the qos-policy-
input configuration mode— (conf-qos-policy-in).
When changing a Service-Queue configuration in a QoS policy map, all QoS rules
are deleted and re-added automatically to ensure that the order of the rules is
maintained. As a result, the Matched Packets value shown in the show qos
statistics command is reset.
Related rate police
Commands
1360
Enter the name for the policy map in character format (32
characters maximum).
(OPTIONAL) Enter the keyword cpu-qos keyword to assign
this ACL to control plane traffic only.
(OPTIONAL) Enter the keyword layer2 to specify a Layer 2
Class Map. The default is Layer 3.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
— incoming traffic policing function.
Quality of Service (QoS)