Speaker Tracking - Cisco TelePresence MX200 G2 User Manual

47 Camera

Speaker Tracking

To enable Speaker Tracking, tap Camera, as outlined.
Tap anywhere outside the menu to exit.
To deactivate Speaker Tracking, repeat the procedure.
Activate the Speaker Tracking feature by tapping as
outlined.
Tip Systems with speaker tracking may include the Snap to
Whiteboard feature. This feature must have been activated
by your video support team to work.
Snap to Whiteboard will cause the camera to display a
predefined whiteboard area as well as a person standing by
the whiteboard.
If Snap to Whiteboard has not been activated, the
camera will zoom in on the person only and not show the
whiteboard.
Snap to Whiteboard will only work if a person is standing by
the whiteboard and speaking. This has been implemented
by design to make it possible to sit in front of the whiteboard
without triggering the snap feature.
About Speaker Tracking
Systems equipped with a speaker
tracking camera system use two
cameras working together with
a built-in microphone array. The
system will track and show the
person speaking so that you won't
have to use the Camera Control
menu or Camera Presets to zoom in
and out.
When speaker tracking has been
activated, the camera position
presets will still be available.
However, if you tap a camera
position preset while in speaker
tracking mode, one of the cameras
will respond accordingly and the
speaker tracking will be deactivated.
Activate speaker tracking as shown
on this page again, if needed.
Note that
speaker tracking will not
work if the microphones are muted.
Speaker tracking may be expanded
to include the Snap to Whiteboard
feature, as discussed in the tip at left.
D1507606 User Guide
Cisco TelePresence SX10, SX20, MX200 G2,
MX300 G2, MX700, MX800, SX80
Produced: December 2014 for TC 7..3
All contents © 2010–2014
Cisco Systems, Inc. All rights reserved.