▀ Source and Destination Configuration
Source and Destination Configuration
This section provides information about the source and destination configuration file parameters. The source and
destination configuration file, ess_sourcedest_config, is located in the directory where the installable tar file is extracted.
This config file can be loaded to a database using a config utility called lessConfigUtility.sh. This script can
also be used to add/remove/modify the configuration for particular source/destination, and other miscellaneous
configurations like changing config parameters and adding/removing/modifying SNMP host.
The config file based configuration is provided to load source/destination config in bulk. Please note the following
points:
Common configuration parameters will be applied to all source/destination configured through the config file.
If any parameter is changed from particular source/destination configuration block then changed value will be
applied to source/destination instead of the value from common config.
Destination can be configured from "common local destination block" / "common remote destination block" /
"destination block per source".
If the source block is having corresponding destination configuration then same configuration will be used for
destination.
If the source does not have corresponding destination configuration then configuration from "common local
destination block"/ "common remote destination block" will be used depending on the location (R - Remote / L
- Local) value.
Source-Destination mapping
Source Path1,Filter1 mapped to Destination Path1,subdirectory1,Filter1
Source Path2,Filter2 mapped to Destination Path2,subdirectory2,Filter2
Source Path5,Filter5 mapped to Destination Path5,subdirectory5,Filter5
To load the source/destination config file after the L-ESS installation is complete:
1. Modify the source/destination config file template as per the requirements.
2. Use the config utility present in the <less_install_dir>/ess directory to validate and load the config file.
./lessConfigUtility.sh [Options] [Config File Path]
The [Config File Path] is the path where the config file is present.
▄ Cisco ASR 5000 Series External Storage Server Installation and Administration Guide
72
Options
Description
-l
Load the config file.
-v
Validate the config file.
-c
Clean all configurations.
-p
Print all configurations.
-h
Display help.
Configuring the L-ESS Server
OL-22979-03