Help - Motorola StarTAC SC200 Owner's Manual

12. Help

No dial tone
• Use only the telephone line cord supplied.
• Check that the telephone line cord is
connected properly.
• Check that the mains power is connected properly
and switched on.
No display on the corded base
• Check that the mains power is connected properly
and switched on.
• Reset the base by disconnecting the mains power.
• Leave for a few seconds and reconnect.
No display on the cordless handset
• Check that the batteries are inserted correctly and
fully charged. Use only approved rechargeable
batteries supplied.
• Check that the handset is switched on. Press and
hold .
• Reset the base by removing the batteries and
disconnecting the mains power. Wait for around 15
seconds before connecting it again. Allow up to one
minute for the handset and base to synchronize.
Help
icon flashes
• Handset is out of range. Move closer to the base.
• Make sure that the handset is registered to the base,
see page 31.
• Check that the mains power is connected properly
and switched on.
Keypad does not seem to work
• Check that the keypad lock is not on, see pages 18
and 24.
icon is not flashing during charge
• Adjust the handset slightly on the base.
• Clean the charging contacts with a cloth moistened
with alcohol.
• Check that the mains power is connected properly
and switched on.
• The battery is full. When the handset is fully charged,
will appear steady on the display.
No Caller ID
• Check your subscription with your network operator,
see pages 19 and 35.
• The caller may have withheld their number.
• The record cannot be found in your phonebook.
Check that you have the correct name / number
stored in your phonebook, with the full area code.
37