10. Advanced settings
10.1
Change the PIN code
Some functions are protected by a 4 digit PIN code which
must be entered if you want to change the settings. The
default PIN is 0000. You can change this to your own
preferred number, the maximum length is 8 digits.
When you enter a PIN, the digits are shown as ****.
1. Press
, the display shows PHONEBOOK.
2. Scroll
to ADVANCED SET
3.
The display shows CHANGE
4. Enter the current 4 digit PIN code and press
5. Enter the new PIN and press
6. Press
to return to standby.
Note
If you forget your PIN you can reset the handset to take it
back to the default setting.
10.2
Registration
You can register up to 4 cordless handsets to your SC200
corded base to extend your phone system without having
to install extension sockets for each new phone.
Each SC200 cordless handset can be registered with up
to four bases. You can then select the base you prefer
to use.
Advanced settings
and press
.
.
PIN. Press
.
.
The SC200 cordless handset comes pre-registered to
the base.
If you have purchased an additional handset separately,
you must register it to your SC200 base before it can
be used.
10.2.1 Register an additional handset
On the base:
1. Press and hold for 5 seconds until you hear a
continuous beep. The base will remain in registration
mode for 60 seconds.
On the handset:
1. Press
, the display shows PHONEBOOK.
2. Scroll
to ADVANCED SET
3. Scroll
to REGISTRATION and press
4. Enter the PIN code and press
5. The display shows WAITING, you will hear a beep
if the registration is successful. The handset is
automatically assigned an available handset number.
Use this number when making internal calls.
10.2.2 Register a different make of handset to your
SC200 base
IMPORTANT
DECT GAP Profile only guarantees that basic calling
and press
.
.
.
31