ENGLISH (Original instructions) SPECIFICATIONS Model HR3000C Concrete 30 mm Core bit 90 mm Capacities Steel 13 mm Wood 30 mm No load speed (min 360 - 720 Blows per minute 1,650 - 3,300 Overall length 391 mm Net weight 5.1 kg Safety class •...
Power tool plugs must match the outlet. Never Makita Corporation responsible modify the plug in any way. Do not use any manufacturer declare that the following Makita adapter plugs with earthed (grounded) power machine(s): tools. Unmodified plugs and matching outlets will Designation of Machine: reduce risk of electric shock.
up or carrying the tool. Carrying power tools with Service your finger on the switch or energising power tools 25. Have your power tool serviced by a qualified that have the switch on invites accidents. repair person using only identical replacement 14.
14. Some material contains chemicals which may revolutions/blows per minute. be toxic. Take caution to prevent dust Revolutions per inhalation and skin contact. Follow material Number on adjusting Blows per minute dial minute supplier safety data. 3,300 3,150 SAVE THESE INSTRUCTIONS. 2,700 2,250 1,800...
Hammering only Indicator lamp 1. Pointer 1. Power-ON 2. Hammering only indicator lamp symbol (green) 2. Service indicator lamp (red) 003134 003137 For chipping, scaling or demolition operations, depress The green power-ON indicator lamp lights up when the the lock button and rotate the change lever so that the tool is switched ON.
Page 7
The bit can be secured at 12 different angles. To change Installing or removing the bit the bit angle, depress the lock button and rotate the change lever so that the pointer points to the "O" symbol. 1. Bit shank Turn the bit to the desired angle.
Chipping/Scaling/Demolition Bit diameter Dust cup 5 6 mm - 14.5 mm Dust cup 9 12 mm - 16 mm 006406 OPERATION Hammer drilling operation 003204 Set the change lever and the shift lever to the symbol. Hold the tool firmly with both hands. Turn the tool on and apply slight pressure on the tool so that the tool will not bounce around, uncontrolled.
Wipe out the old grease inside and replace with a fresh Use a screwdriver to remove the brush holder caps. Take grease (30 g). Use only Makita genuine hammer grease out the worn carbon brushes, insert the new ones and (optional accessory).
Page 10
Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. SDS-Plus Carbide-tipped bits • Bull point • Cold chisel •...
Page 12
Makita Corporation Anjo, Aichi, Japan www.makita.com 884253E223...