Fusing Unit Drive; Heater Lamp Drive; Fusing Operation; Fusing Temperature Control - Sharp MX-2300 G Service Manual

Signal name Name
HL_US Heater lamp (2)
RTH3 Fusing temperature sensor (3)
HLTS3 Thermostat (3)
HL_LM Heater lamp (3)
FUM Fusing motor
No. Name
1 Fusing roller (Heating)
2 Pawl
3 Fusing roller (pressing)

2. Operational descriptions

A. Fusing unit drive
To drive the fusing unit, the drive power is transmitted from the
drive motor (FUM) through the connection gear to the upper heat
roller gear.
The drive motor (stepping motor) is driven according to the control
signal sent from the PCU.
PCU
B. Heater lamp drive
The surface temperature of the heat roller detected by the ther-
mistor is sent to the PCU. When the temperature is lower than the
specified level, the heater lamp lighting signal is sent from the PCU
to the heater lamp drive circuit in the sub power PWB.
The power triac in the heater lamp drive circuit is turned on, and the
AC power is supplied to the heater lamp, lighting the lamp and
heating the heat roller.
To prepare for an abnormally high temperature of the heat roller,
the thermostat is provided for safety.
When the thermostat is opened, power supply (AC line) to the
heater lamp is cut off.
C. Fusing operation
Color toner of YMCK on paper is heated and pressed by the heat
rollers to be fused on paper.
At that time, color toner of YMCK is mixed to reproduce nearly
actual colors of document images.
Heats the fusing roller (heating).
Detects the surface temperature of the fusing roller (heating).
Shuts conduction to the heater lamp when the temperature rises abnormally. [For the fusing roller (heating)]
Heats the fusing roller (heating).
Drives the fusing unit.
Heat and presses toner on paper to fuse it on paper.
Paper which was not separated naturally from the fusing roller (heating) is mechanically separated.
Heat and presses toner on paper to fuse it on paper.
FUM
MX-2300/2700 N/G FUSING SECTION N – 2
Function/Operation
Function/Operation
The upper and the lower heat rollers are provided to heat from
above and below.
This is because it is necessary to heat four layers of toner from
above and below and right and left to fuse it on paper.
The upper and lower heat rollers are of silicon rubber.
This is because of the following reasons:
1) To provide a greater nip quantity and a higher heating capacity
for paper.
2) The soft, flexible rollers press multi-layer toner without defor-
mation to fuse on paper.
3) An even pressure is applied to an uneven surface of multi-
layer toner.
D. Fusing temperature control
The temperature sensors are provided at the center and the edges
of the upper heat roller, and at the center of the lower heat roller.
The heat roller temperature is detected by the temperature sensors
to control the heater lamp so that the temperature is maintained at
the specified level.
The fusing temperature is switched according to the machine con-
dition and paper type selected.
roller center
Mode Paper
Ready state B/W normal
Print mode paper
Color normal
paper
Heavy paper
OHP
Envelope
Fusing Fusing
Fusing
roller
roller
(heating) (heating)
(pressing)
main sub
170 180 130
170 180 130
170 175 140
170 170 145
180 180 145