Cisco TelePresence SX10 Quick Set Administrator's Manual page 17

Cisco TelePresence SX10 Quick Set
Contents
Placing a call
You can use the Call Control page to place a call.
It is the video system (display, microphones and
loudspeakers) that is used for the call; it is not the PC
running the web interface.
Calling
You can call someone either by choosing a contact name in
the Local, Directory or Recents lists, or by typing a complete
URI or number in the Search or Dial field. Then click
the associated contact card.
Searching the contact lists
Enter one or more characters in the Search or Dial field.
Matching entries from the Local, Directory and Recents lists
will be listed as you type.
Select the correct entry in the list and click Call.
Calling more than one
Calling more than one using a conference bridge (CUCM ad
hoc conferencing) is not supported from the web interface,
even if it is supported by the video system itself.
Whether or not snapshots of input sources are shown as illustrated,
depends on the software version, configuration, and options installed
on the video system. Refer to the About snapshots and remote
monitoring sections (► TC7.3.3 or newer or
D15106.04 SX10 Quick Set Administrator Guide TC7.3, JULY 2015.
Introduction Web interface Web interface
Navigate to: Call Control
Call in
Click a contact name, either in the
Then click
Alternatively, enter the complete URI
or number in the Search and Dial
field. Then click the
appears next to the URI or number.
► TC7.3.0 to TC7.3.2).
System settings
Calling someone
Local, Directory or Recents lists.
Call in the contact card.
Call button that
17
Setting passwords
Holding and resuming Ending a call
If you want to terminate a
Use the button next
call, click
to the participant's name
button.
to put him on hold.
To resume the call,
use the button
that is present when a
participant is on hold.
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
Administrator Guide
Appendices
End all or the